Finishing Event Horizon V3.2 Part 2: Machining

Much progress was made today. I will need to make a trip to the local plastic supplier to get the stock for the wheels and new front blocks, place an Online Metals order for the armor plates, and place a McMaster order for new shoulder bolts and a few other things. In the meantime, however, I got to work machining the new drum internals and side plates. I also need to work on machining the blades, which I have been avoiding for several months, but I am going to continue putting that off.

Before I do a spin up test with the blades, I'll need to make a testing box. It could be extremely dangerous if one of the blades comes off with the drum at full speed. They are sharp enough to shave hairs off of my arm.

The first things on the table are all of the 3/8" UHMW parts. I have taken to doing my CNC work in large sheets. Here is a sheet containing all of the parts that need to be machined. I will need to make fixturing pieces to do the finish machining on the new front blocks, but that is a project for another day.

CNC Sheet of changed parts

If anyone is curious, I use the HSM plugin for Autodesk Inventor for writing G-Code. My CNC router is running Mach 3.

I tried a new endmill for these parts. It is an Amana Tool 1/8" plastic cutting bit, which I tacked onto a re-stocking order of 1/8" aluminum cutting bits made by the same company. The finish was slightly better than the old 1/8" straight flute mill that I have used in the past. I used twice my normal cutting depth and it worked well. In the future, I think I will use a slower feed because the finish is a bit rough.

After finishing the new UHMW pieces, I went back to the drum and machined a new idler axle. Originally, I was going to make a press fit for the axle, but I decided that there are several situations that may warrant removing the axle, so I enlarged the hole slightly so that it is just a tight slip fit.

Idler shaft and motor in drum

The bearing system on the idler side of the drum is just the aluminum shaft resting in a hole in the frame member. I used a reamer to bore out the hole, which left a good finish. I then added some spindle oil. This resulted in a surprisingly smooth bearing, though I am concerned about frame deformations causing it to lock up. I think I'll leave it for now, at least until I have the opportunity to do some testing.

Drum attached to the new frame